Bsc Preferred HLT140 Hook and Loop Tape Roll

Product Description

The BSC PREFERRED HLT140 is a hook and loop fastener tape roll designed for mounting and hanging applications across trade and commercial environments. The system uses a touch-closure mechanism: when the hook and loop sides are pressed together, hundreds of hooks interlock with hundreds of loops to form a secure bond. Separating the two sides causes the hooks to straighten and release cleanly. The pressure-sensitive adhesive backing is rubber-based, rated for both high and low temperature environments, and the tape is constructed to resist weather exposure. This product is sold as a single component - hook and loop sides are sold separately. Installation does not require tools or fasteners beyond surface preparation.

This tape roll is suited for hanging signs, posters, displays, and lightweight tools in retail, commercial, and light industrial settings. It applies to most clean, dry surfaces and is appropriate for both indoor and outdoor use given its weather-resistant construction. The rubber-based adhesive maintains bond strength across a range of ambient temperatures, making it a practical fastener choice in environments where temperatures fluctuate. The HLT140 ships as a single roll (one component side per roll) with a minimum order quantity of one roll.

Key Features

• Touch-closure hook and loop mechanism forms a secure interlock on contact
• Rubber-based pressure-sensitive adhesive suitable for high and low temperature environments
• Weather-resistant construction for indoor and outdoor use
• No tools required for installation - press-and-stick application
• Hook and loop sides sold separately, allowing independent replacement of each component

Compatibility

This product is noted as equivalent to part number S-13612. Designed as a general-purpose hook and loop fastener tape for mounting, hanging, and display applications across hardware and fastener categories.

Installation Notes

Surface preparation is critical for adhesive performance - clean the mounting surface with isopropyl alcohol and allow it to dry fully before applying the tape. Apply firm, even pressure along the full length of the tape after placement to ensure adhesive contact. Power down or de-energize any equipment before applying near electrical panels or control surfaces. Hook and loop sides must be purchased and applied as separate components.