Bsc Preferred ECTRU24169RTFCW Workstation Kitchen Sink

Product Description

The BSC PREFERRED ECTRU24169RTFCW is an 18-gauge Type 304 stainless steel single-bowl undermount workstation sink designed for residential kitchen installation. The sink measures 25.5 inches in length, 18.5 inches in width, and 9 inches in depth, offering a large-capacity rectangular bowl suitable for oversized cookware, sheet pans, and stockpots. An integrated workstation ledge runs the perimeter of the sink, allowing accessories to slide along the track during prep and cleanup. Sound-dampening pads and a spray-applied undercoating reduce basin noise during use. A rear-right drain placement keeps the basin floor clear and maximizes usable cabinet space below. This sink is installed by licensed plumbers or experienced contractors.

The ECTRU24169RTFCW is suited for residential kitchen remodel and new construction applications where an undermount single-bowl configuration is specified. The workstation ledge supports the included accessory kit, which contains a bottom grid, drying rack, colander, and cutting board. Tight-radius corners simplify routine cleaning. The rear-right drain position is particularly useful when pairing the sink with under-sink filtration or disposal units. A minimum cabinet opening of 30 inches is required for proper fit. The brushed stainless steel finish is compatible with a wide range of kitchen fixture finishes.

Key Features

• 18-gauge Type 304 stainless steel construction for corrosion resistance and long-term durability
• Integrated workstation ledge accommodates sliding accessories including grid, rack, colander, and cutting board
• Rear-right drain placement maximizes usable basin floor area and under-sink cabinet space
• Sound-dampening pads and spray undercoating reduce operational noise
• Deep 9-inch bowl handles large cookware and baking sheets without obstruction
• Tight-corner rectangular geometry simplifies surface cleaning

Compatibility

Designed as an undermount single-bowl workstation sink requiring a minimum 30-inch base cabinet. Accessory kit including bottom grid, drying rack, colander, and cutting board is included as stated by the manufacturer.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC guidelines. Shut off the water supply and disconnect existing drain and supply lines before beginning removal of any existing sink. Use manufacturer-approved undermount clip hardware and silicone adhesive rated for stainless steel and stone or solid-surface countertop materials. Verify cabinet rough opening dimensions against the 30-inch minimum requirement before cutting the countertop.