Bsc Preferred 330140GA Wet Sandpaper 4 Sheet Pack

Product Description

The BSC PREFERRED 330140GA is a 4-pack of assorted-grit silicon carbide wet sandpaper sheets sized 9 x 11 inches. Silicon carbide abrasive cuts aggressively on both wet and dry surfaces, making it a standard choice for sanding between coats of paint, sealer, varnish, lacquer, and other finish coatings. Each sheet uses a resin bond that resists moisture breakdown longer than conventional glue-bonded paper, so the sheet holds together through wet sanding passes without delaminating prematurely. The assorted-grit pack gives a finisher multiple grit stages in a single purchase, reducing downtime between coats on refinishing and surface prep work.

These sheets are suited for automotive bodywork, furniture refinishing, cabinetry, and general surface preparation where a smooth, defect-free finish is required before a final topcoat. The wet sanding method reduces dust, minimizes scratch depth, and produces a finer surface profile than dry sanding at equivalent grit levels. Painters, body technicians, and finishing carpenters commonly use silicon carbide sheets at this size as a shop standard for between-coat leveling work.

Key Features

• Silicon carbide abrasive grain for aggressive, consistent cutting on wet or dry surfaces
• Resin bond coating outlasts ordinary glue bond construction in wet sanding applications
• 9 x 11 inch sheet size fits standard hand-sanding blocks and pad holders
• Assorted grit selection supports multiple stages of between-coat finishing in one pack
• Suitable for paint, sealer, varnish, lacquer, and other finish coatings

Compatibility

Designed for use as a general-purpose wet or dry sandpaper sheet compatible with hand-sanding blocks and standard 9 x 11 inch pad holders used in automotive, woodworking, and finishing applications.

Installation Notes

These sheets are installed by hand or wrapped around a sanding block. For wet sanding, saturate the sheet and substrate surface with clean water or an appropriate lubricant before use. Allow finish coats to cure fully per the coating manufacturer's recommendations before sanding. Dispose of used sheets and sanding slurry in accordance with local regulations, particularly when sanding lead-based or solvent-based finishes.