Brother International HSE251E Heat Shrink Tube Label Roll

Product Description

The BROTHER INTERNATIONAL HSE251E is a heat shrink tube label roll designed for use with compatible Brother label printing systems. Measuring 0.82 inches wide and 4.9 feet in length, this roll provides a compact supply of heat shrink tubing media for printing identification labels directly onto shrinkable sleeve material. Electricians and low-voltage installers use heat shrink tube labels to mark wire bundles, cable runs, terminal blocks, and conduit at panels and junction points. Each unit is sold individually and is classified as a labeling refill consumable.

Heat shrink tube labels are most commonly applied in electrical and data-cabling environments where durable, permanent wire identification is required. The HSE251E roll is suited for residential and light commercial panel work, structured wiring installations, and industrial wire harnessing where labels must survive heat, abrasion, and tight routing conditions. Install technicians print the label, slide it over the conductor or bundle, and apply heat to shrink the sleeve into a secure, readable marker.

Key Features

• 0.82-inch width accommodates a range of wire and cable diameters after shrinking
• 4.9-foot roll length provides multiple labels per cassette
• Heat shrink media format creates a durable, abrasion-resistant wire marker
• Sold as a single roll refill unit, no additional quantity pack
• Designed for use with Brother heat shrink tube label printing systems

Compatibility

Designed as an OEM-style labeling refill for compatible Brother heat shrink tube label printers. No specific compatible model numbers were provided in the product data.

Installation Notes

Heat shrink tube labels are installed by electricians and low-voltage technicians following applicable NEC guidelines for wire identification and marking. Before applying heat to shrink the sleeve, confirm the conductor or bundle is de-energized and the printed label orientation is correct. Use a heat gun set to the appropriate temperature for the tube material — do not use an open flame. Ensure the sleeve is fully seated over the intended conductor before shrinking to avoid repositioning a set label.