Bosch HCBG0205T Blugranite Turbo Hammer Drill Bit 5 Pack

Product Description

The ROBERT BOSCH TOOL GROUP HCBG0205T is a 5-pack of BluGranite Turbo carbide hammer drill bits sized at 5/32-inch diameter and 6 inches overall length with a 3-inch flute length. These bits are engineered for demanding masonry applications, featuring a 4-grind carbide head that adds two extra cutting angles for faster penetration and longer service life. Bosch-made carbide construction handles heavy loads without premature wear. The hex shank design is impact-rated, making these bits compatible with both hammer drill/drivers and impact drivers. Licensed HVAC, plumbing, and electrical contractors as well as general construction tradespeople will find these bits suited to anchor installation, conduit routing, and rough-in work through brick, block, and concrete.

These bits are designed for use in residential and commercial construction environments where masonry drilling is required. The milled U-flutes with deep-cut spirals evacuate dust rapidly, reducing bit binding and heat buildup during continuous use. The multi-grind carbide centering tip seats accurately in brick, block, CMU, and similar masonry surfaces without walking. The impact-rated hex shank expands compatibility to cordless impact drivers, giving tradespeople flexibility when a dedicated hammer drill is not on hand. Each 5-pack is suited for high-volume work where bit replacement is routine.

Key Features

• 4-grind carbide head with two additional cutting angles for faster drilling speed and extended bit life
• Impact-rated hex shank compatible with hammer drill/drivers and impact drivers
• Multi-grind carbide centering tip for accurate starts in brick and masonry without walking
• Milled U-flutes with deep-cut spirals for rapid dust evacuation and reduced heat buildup
• Bosch-made carbide construction rated for outstanding durability under heavy loads
• 5-pack quantity supports high-volume or multi-trade jobsite use

Compatibility

Designed for use in hammer drill/drivers and impact drivers accepting a hex shank. Suitable for drilling into brick, concrete block, CMU, and general masonry substrates.

Installation Notes

Installation is performed by tradespeople drilling masonry for anchors, conduit supports, or structural fasteners. Confirm the tool is set to hammer mode when using a hammer drill/driver for full percussion performance. Wear appropriate eye protection and a dust mask when drilling masonry, as silica dust is a respiratory hazard. Do not use in a standard rotary-only drill mode where hammer action is required for the material.