Bosch HC2302 Sds Plus Hex Drive Rotary Hammer Bit 5-pack

Product Description

The ROBERT BOSCH TOOL GROUP HC2302 is an SDS Plus Bulldog rotary hammer bit designed for setting screws in concrete and masonry fastening applications. It measures 5/32 inches in diameter with a 3-1/2 inch working length and an overall length of 6-1/2 inches, including a 3.5 inch reusable length. The hex drive shank seats directly into a compatible driver sleeve, enabling faster screw-setting cycles compared to standard rotary hammer bits. Each package contains 5 bits. Licensed HVAC techs, plumbers, electricians, and general tradespeople use this bit when anchoring equipment, conduit supports, or structural fasteners into concrete substrates.

This bit is intended for use with masonry fastening systems and hex sleeve drive tools that accept the SDS Plus interface. It is well suited to commercial and residential concrete applications where setting threaded fasteners quickly and repeatedly is required. The hex drive geometry on the bit shank locks into the driver sleeve without slipping, maintaining alignment during high-torque rotary hammer operation. The 3.5 inch reusable length allows the bit to be reused across multiple setting cycles before replacement is necessary.

Key Features

• SDS Plus shank for compatibility with SDS Plus rotary hammers and driver sleeves
• Hex drive on bit shank seats securely into masonry fastening system driver sleeves
• Rated 20 percent faster than standard rotary hammer bits for screw-setting cycles
• 3.5 inch reusable length allows multiple setting operations per bit
• 5/32 inch diameter suited to common concrete fastener sizes
• Sold in a 5-pack for job-site convenience and replacement stock

Compatibility

Designed for use with masonry fastening systems and hex sleeve drive tools that accept the SDS Plus interface, including Bulldog-series rotary hammer driver sleeves.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with rotary hammer operation and applicable safety codes. Always power down or unplug the rotary hammer before inserting or removing the bit from the driver sleeve. Wear appropriate eye and hearing protection when driving fasteners into concrete. Verify that the hex drive is fully seated in the driver sleeve before applying load to prevent bit slippage or premature wear.