Bosch DSB5006 6 Piece Spade Bit Set Wood Drilling

Product Description

The ROBERT BOSCH TOOL GROUP DSB5006 is a 6-piece Dare Devil standard spade bit set designed for fast, accurate drilling in wood and wood-composite materials. The set features a full cone threaded tip that pulls the bit into the workpiece for efficient, low-effort penetration. A contoured paddle design accelerates chip removal, reducing heat buildup and keeping cuts clean. Spur and reamer tips at the outer edges of each paddle produce cleaner hole walls and minimize blowout on the exit side. The hex shank power groove reduces slippage in drill chucks. Licensed electricians, HVAC technicians, and general contractors commonly use this set when boring through framing, studs, and joists during rough-in work.

This spade bit set covers the most common rough-in bore sizes in one kit. The six included sizes span from 3/8 inches up to 1 inch, making the set suitable for drilling wire and pipe pass-through holes in residential and light commercial framing. It is compatible with standard drill and impact drivers equipped with a 1/4-inch hex chuck. The set is appropriate for any trade requiring repeated large-diameter holes through dimensional lumber or engineered wood products during installation or retrofit work.

Key Features

• Full cone threaded tip pulls the bit into material for fast, low-effort drilling
• Contoured paddle design promotes rapid chip evacuation and reduced heat
• Spur and reamer tips deliver cleaner hole walls and reduced exit breakout
• Hex shank power groove minimizes slippage in standard 1/4-inch hex chucks
• Six-piece set covers 3/8, 1/2, 5/8, 3/4, 7/8, and 1 inch bore sizes

Compatibility

Designed for use with standard drills and impact drivers equipped with a 1/4-inch hex chuck. Intended for drilling through wood and wood-composite materials. No specific model compatibility data was provided by the manufacturer for this listing.

Installation Notes

Spade bits are installed by trade professionals including electricians, plumbers, and HVAC technicians during rough-in phases. Always confirm the drill or driver is powered off and the battery is removed or the tool is unplugged before changing bits. Secure the workpiece before drilling, and apply steady, consistent feed pressure without forcing the bit. Follow all applicable NEC, IPC, or IFGC clearance and protection requirements when boring through structural members.