Bessey D50 Multi-purpose Snips 7-5/8 in Straight Cut

Product Description

The BESSEY D50 is a multi-purpose snip designed for straight cutting of sheet metal, wire mesh, plastic sheeting, and similar trade materials. Built with stainless steel blades, the D50 delivers clean, repeatable cuts with a 1-5/8 inch cutting length. The overall tool length of 7-5/8 inches gives technicians and tradespeople a compact, maneuverable grip in tight workspaces. With a maximum steel cutting capacity of 22 AWG, this snip handles light-gauge sheet metal typically encountered in HVAC ductwork fabrication, plumbing rough-in, and general mechanical work. The black and red plastic handle provides grip comfort during extended use.

The BESSEY D50 is suited for residential and light commercial applications where straight-line cuts through thin-gauge steel, stainless, or non-ferrous sheet are required. HVAC installers use snips like the D50 for trimming duct collars, sheet metal patches, and flashing. Electricians and plumbers reach for a compact multi-purpose snip when cutting strapping, flashing, or thin sheet material on the job. The straight cutting direction makes this tool appropriate for precise linear cuts without the offset geometry of aviation-style snips.

Key Features

• Stainless steel blades for corrosion resistance and edge retention
• 1-5/8 inch cutting length accommodates typical sheet metal trim work
• Straight cutting direction for accurate linear cuts
• 22 AWG maximum steel cutting capacity suitable for light-gauge sheet metal
• Compact 7-5/8 inch overall length for use in confined spaces
• Black and red plastic handle for grip and identification

Compatibility

Designed as a general-purpose hand snip for light-gauge sheet metal cutting applications common in HVAC, plumbing, and general mechanical trade work.

Installation Notes

No power source is required for operation. Always wear cut-resistant gloves when working with sheet metal edges, as freshly cut metal can be sharp. Inspect blade alignment before use and avoid cutting materials that exceed the 22 AWG rated steel capacity to prevent blade damage. Snips should be cleaned and lubricated at the pivot point periodically to maintain smooth action.