Belden Inc. FI4D006R9 OM4 6-fiber Multimode Riser Cable

Product Description

The BELDEN INC. FI4D006R9 is a multimode riser-rated optical fiber cable designed for high-density indoor backbone and vertical run installations. Built to OM4 performance specifications, this 6-fiber cable supports high-bandwidth applications including 10 Gigabit, 40 Gigabit, and 100 Gigabit Ethernet over extended distances. The OFNR (Optical Fiber Nonconductive Riser) rating qualifies it for installation in riser pathways between floors without the need for conduit in jurisdictions that accept riser-rated cable. Licensed low-voltage and datacom technicians are the primary installers of this product.

This cable is suited for commercial and institutional structured cabling systems where OM4 multimode fiber is specified. Typical applications include inter-floor backbone runs in office buildings, data centers, schools, and healthcare facilities. The 6-fiber count makes it a practical choice for moderate-density runs where multiple duplex circuits or small MTP/MPO breakout configurations are required. It is sold and handled as individual units per the supplier unit-of-measure designation.

Key Features

• OM4 multimode fiber grade supports 10GbE, 40GbE, and 100GbE transmission
• OFNR riser rating meets NEC Article 770 requirements for vertical cable runs between floors
• 6-fiber construction provides capacity for multiple duplex or parallel optical circuits
• Nonconductive design eliminates grounding requirements at cable entry points
• Indoor-rated construction suitable for plenum-free riser pathways

Compatibility

Designed as a riser-rated OM4 multimode fiber cable for use in structured cabling systems that comply with ANSI/TIA-568 multimode fiber standards. No specific compatible models or systems were identified in the available product data.

Installation Notes

Installation should be performed by a licensed low-voltage technician or registered communications distribution designer familiar with NEC Article 770 fiber optic wiring requirements. De-energize and lock out any equipment associated with the cable pathway before beginning work. Observe the manufacturer minimum bend radius during pulling and termination to avoid microbend losses. Do not exceed the rated tensile load during cable pulls through riser sleeves or conduit.