Belden Inc. D6UR 004U1000 Cat6 Cable 4 Pair 23 Awg Yellow

Product Description

The BELDEN INC. D6UR 004U1000 is a Category 6 unshielded twisted-pair (UTP) Ethernet cable rated for plenum-space installation. Built with 4 pairs of 23 AWG solid copper conductors, it meets the performance demands of structured cabling systems carrying voice, data, and video traffic at Gigabit speeds. The plenum rating means the jacket compound meets smoke and flame spread requirements for air-handling spaces, making it the correct choice when local codes require CMP-rated cable. Licensed electricians and low-voltage cabling technicians are the primary installers.

This cable is suited for horizontal runs in commercial and residential structured cabling installations where the cable must pass through HVAC plenum air-handling spaces or open ceiling cavities governed by plenum fire codes. Typical applications include office network drops, IP camera runs, VoIP phone wiring, and access control backbone cabling. The yellow jacket provides visual identification for network segregation or zone labeling on a job site.

Key Features

• Category 6 performance supports Gigabit Ethernet and high-bandwidth data applications
• 4-pair 23 AWG solid copper construction for full horizontal-run performance
• Plenum-rated jacket meets CMP smoke and flame spread requirements for air-handling spaces
• Yellow jacket enables quick visual identification and zone segregation
• Sold per unit (EA), 1 unit per order quantity

Compatibility

Designed as a standard Category 6 UTP plenum cable compatible with 568-A and 568-B termination schemes using standard Cat6 keystone jacks, patch panels, and RJ45 connectors in structured cabling systems.

Installation Notes

Installation should be performed by a licensed electrician or qualified low-voltage cabling technician in accordance with NFPA 70 (NEC) Article 800 and local AHJ requirements. Verify that plenum-rated cable is required by the local code and the specific routing path before pulling. Avoid sharp bends, kinks, or exceeding the minimum bend radius during installation, as these can degrade Cat6 signal performance. Power down active network equipment at patch panel termination points before making connections.