Belden Inc. 8185060500 Multimedia Cable 25 Pair

Product Description

The BELDEN INC. 8185060500 is a shielded multimedia cable designed for structured wiring and low-voltage signal distribution applications. Built with 25 pairs of 24 AWG conductors and a foamed high-density polyethylene (FHDPE) dielectric, this cable is engineered for clean signal transmission with minimal crosstalk. The PVC outer jacket provides durable protection against abrasion and common installation hazards. Licensed low-voltage technicians and communications cabling contractors typically specify this cable for commercial and residential data, audio, or control system runs where pair count and shielding are critical design requirements.

This cable is suited for installations requiring multi-pair shielded runs in structured cabling environments, control systems, or multimedia distribution. The 25-pair configuration makes it a common choice for telephony backbone runs, intercom systems, and centralized AV or building automation wiring. The FHDPE dielectric contributes to consistent impedance characteristics across the cable length, which is important in longer runs or high-density panel terminations. Installation in both commercial and residential settings is supported by the PVC jacket construction.

Key Features

• 25-pair construction supports high-density, multi-circuit low-voltage wiring in a single cable run
• 24 AWG conductor size balances flexibility with adequate current-carrying capacity for signal applications
• Foamed high-density polyethylene (FHDPE) dielectric provides consistent impedance and reduced signal loss
• Overall shield helps reject electromagnetic interference (EMI) and radio frequency interference (RFI)
• PVC outer jacket offers abrasion resistance and durability for standard indoor installation environments

Compatibility

Designed as an OEM-style replacement or direct specification cable for shielded multi-pair multimedia and low-voltage signal distribution installations.

Installation Notes

Installation should be performed by a licensed low-voltage or communications cabling technician in accordance with applicable NEC Article 725 or 800 requirements for signaling and communications cables. Power down or de-energize all connected equipment before terminating or splicing. Avoid sharp bends that exceed the cable minimum bend radius, and keep runs separated from high-voltage conductors to maintain shield effectiveness. Terminate the shield drain wire at only one end unless system design specifies otherwise to prevent ground loops.