Belden FPS4F4F008M OS2 Fiber Patch Cable MPO8 MPO8 8M

Product Description

The Belden FPS4F4F008M is an OS2 single-mode fiber optic patch cable configured with MPO8 female connectors on both ends and a cable length of 8 meters. This assembly is used to interconnect fiber optic equipment in structured cabling systems, data centers, and high-density optical distribution frames. OS2 single-mode construction supports long-distance, high-bandwidth transmission with low signal loss, making this cable suitable for backbone and interconnect runs where precision alignment and reliable optical performance are required. Installation is typically performed by licensed low-voltage technicians or data communications contractors familiar with fiber optic handling and termination standards.

This patch cable is designed for use in data center environments, telecommunications rooms, and enterprise network infrastructure where MPO8 connectivity is required. The OS2 single-mode fiber specification supports extended reach applications. It is sold as a single unit and is ready to install as a pre-terminated assembly, eliminating field termination requirements. Typical applications include cross-connects between optical switches, patch panels, and transceivers that use the MPO8 interface standard.

Key Features

• OS2 single-mode fiber construction for low-loss, long-distance optical transmission
• MPO8 female connectors on both ends for high-density fiber connectivity
• 8-meter length accommodates mid-range rack-to-rack and panel-to-panel runs
• Pre-terminated factory assembly eliminates field polishing and termination
• Suitable for high-density structured cabling and data center backbone applications

Compatibility

Designed as a pre-terminated OS2 single-mode fiber patch cable for use with equipment and panels supporting MPO8 female interface connections in structured cabling and data center environments.

Installation Notes

Installation should be performed by a qualified low-voltage technician or fiber optic specialist following applicable TIA and IEC structured cabling standards. Power down or disable active optical equipment before connecting or disconnecting fiber patch cables to prevent eye hazard from laser emissions. Inspect connector end-faces with an appropriate fiber inspection scope before mating, and keep dust caps in place when connectors are not in use. Avoid sharp bends exceeding the cable minimum bend radius to prevent optical signal degradation.