Bando AX44 Cogged V-belt Ax Section 46 in 1/2 in Width

Product Description

The BANDO AX44 is a classic cogged V-belt designed for belt-driven mechanical systems in HVAC, agricultural, industrial, and commercial equipment applications. Built from heat-resistant and oil-resistant rubber, this AX-section belt measures 46 inches in outside length with a 1/2-inch width and 5/16-inch thickness. The cogged construction reduces bending resistance, allowing the belt to flex more efficiently around smaller-diameter sheaves while running cooler than non-cogged equivalents. This belt meets ARPM standards and is a direct replacement for any AX44-specification drive application.

The AX44 is suited for equipment drives where an AX-section belt is specified, including condenser fan drives, blower drives, compressor drives, and general-purpose power transmission systems. The cogged profile improves grip and reduces slippage on variable-speed drives and systems with smaller pulley diameters. It is commonly installed by HVAC technicians, millwrights, and mechanical service professionals during routine belt replacement or equipment overhaul.

Key Features

• Cogged classic V-belt design reduces bending resistance and runs cooler than standard smooth-back belts
• Heat-resistant and oil-resistant rubber construction for durability in demanding drive environments
• AX section with 46-inch outside length and 44-inch internal length for precise fitment
• 1/2-inch width and 5/16-inch thickness conform to AX-section dimensional standards
• Meets ARPM belt standards for quality and dimensional consistency
• Black rubber finish; sold individually

Compatibility

Designed as a direct AX44-specification replacement for any drive system calling for an AX-section cogged V-belt with a 46-inch outside length and 1/2-inch belt width.

Installation Notes

Belt replacement should be performed by a qualified technician with the drive system fully de-energized and locked out per applicable OSHA lockout/tagout procedures. Never pry or roll a belt onto a sheave under tension; always relieve tension using the proper belt tensioner or motor adjustment before installation. Inspect sheave grooves for wear or damage before installing a new belt, and verify sheave alignment to prevent premature wear. After installation, set belt tension per the equipment manufacturer specification before returning the system to service.