Bando AX30 Cogged V-belt Ax Section 32 in 1/2 in Width

Product Description

The BANDO AX30 is a classic cogged V-belt designed for industrial and HVAC drive applications where standard wrapped belts generate excess heat or slip under load. Built from rubber with a cogged (notched) underside profile, this belt runs cooler and more flexibly than smooth-bottom alternatives, making it well suited for smaller-diameter sheaves and high-cycle drives. The AX section designation indicates a 1/2 inch top width and a 5/16 inch thickness. Outside length is 32 inches, with a belt pitch of 31.30 inches and an internal length of 30 inches. Rated heat resistant and oil resistant per ARPM standards, it is a reliable direct replacement in demanding environments.

This belt fits AX-section drive configurations commonly found in residential and light commercial HVAC equipment, including belt-drive blowers, fans, and condensing unit drives. It is also used in agricultural equipment, compressors, and general industrial machinery where an AX-series cogged belt is specified. HVAC technicians, millwrights, and equipment service professionals typically install this belt as a scheduled maintenance replacement or an emergency service part. The single-pack quantity suits one-at-a-time service calls without requiring a bulk purchase.

Key Features

• Cogged (notched) design reduces bending stress and heat buildup on small-diameter sheaves
• Heat resistant and oil resistant rubber construction per ARPM standards
• AX section: 1/2 inch top width, 5/16 inch thickness
• 32 inch outside length, 30 inch internal length, 31.30 inch pitch length
• Classic cogged style for direct cross-reference to AX30 belt specifications
• Sold individually — no minimum bulk purchase required

Compatibility

Designed as an OEM-style replacement for any drive requiring an AX section cogged V-belt with a 32 inch outside length. Cross-references directly to the AX30 belt designation used across multiple equipment manufacturers.

Installation Notes

Belt-drive service should be performed by a qualified HVAC technician or millwright following equipment lockout/tagout procedures before removing guards or tensioning hardware. Align sheaves within manufacturer tolerances before installing the new belt, and set tension per the drive manufacturer specification — over-tensioning shortens bearing and belt life. Do not use belt dressing compounds on cogged rubber belts. Reinstall all belt guards before returning the unit to service.