Bando 5l300 V-belt 5L Section 30 Inch Outside Length

Product Description

The BANDO 5l300 is a light-duty, high-speed drive V-belt designed for fractional horsepower (FHP) applications. Built to the 5L section standard, it features a 0.66-inch top width, a 30-inch outside length, and a 0.375-inch thickness. The belt is constructed from neoprene with polyester reinforcement, providing resistance to heat, oil, and flexing fatigue. It is part of the Duraflex GL FHP series, engineered for smooth, quiet operation in demanding drive configurations. HVAC technicians, equipment service professionals, and mechanical contractors are the primary installers of this belt type.

This belt is suited for residential and light commercial equipment where fractional horsepower drives are common. Typical applications include blower assemblies, fan drives, and small motor-to-load drive systems. The 5L section designation indicates a specific cross-sectional profile used across a wide range of FHP drive setups. A minimum pulley diameter of 3.5 inches is required for proper belt seating and to prevent premature wear or delamination.

Key Features

• 5L section profile with 0.66-inch top width for standard FHP drive compatibility
• 30-inch outside length suitable for common blower and fan drive configurations
• Neoprene construction resists heat, oil exposure, and environmental degradation
• Polyester reinforcement provides high tensile strength and dimensional stability
• Minimum pulley diameter of 3.5 inches to maintain proper belt geometry
• Part of the Duraflex GL FHP series, rated for high-speed drive applications

Compatibility

Designed as an OEM-style replacement for fractional horsepower V-belt drives using the 5L section profile with a 30-inch outside length.

Installation Notes

Belt installation and replacement should be performed by a qualified HVAC technician or mechanical service professional. Always disconnect and lock out power to the drive system before removing or installing a belt. Do not force the belt over pulleys using tools that could damage the cord reinforcement; use proper tensioning procedures and verify alignment of sheaves before returning the system to service. Inspect pulleys for wear or damage before installing a new belt.