Avycon AVA-PSW-12VDH30A-18 Cctv Power Supply 18 Channel

Product Description

The AVYCON AVA-PSW-12VDH30A-18 is an 18-channel DC power supply box designed to distribute 12-volt power to multiple CCTV cameras from a single, centralized enclosure. Rated at 30 amps total output, the unit supports simultaneous operation of up to 18 camera circuits, making it well suited for mid-size to large surveillance installations. Each output channel delivers regulated 12-volt DC power, reducing the need for individual plug-in adapters at each camera location. Licensed electricians and security system installers are the primary trades that source and install this type of distribution hardware.

This power supply box fits into structured CCTV and IP-analog hybrid surveillance systems where centralized power management is preferred over distributed adapters. Typical deployment scenarios include commercial buildings, warehouses, parking structures, and multi-camera residential installations. The 18-channel configuration allows a single enclosure to serve an entire camera run without daisy-chaining or supplemental supplies. The unit is sold individually and is intended for permanent, hardwired installation inside a conduit-fed electrical or low-voltage enclosure.

Key Features

• 18 independent output channels for multi-camera CCTV power distribution
• 12-volt DC output matches standard analog and HD-over-coax camera requirements
• 30-amp total rated output supports high camera counts without additional supplies
• Centralized enclosure design simplifies service and troubleshooting at a single point
• Eliminates individual wall adapters, reducing clutter and potential failure points

Compatibility

Designed as an OEM-style centralized power solution for 12-volt DC CCTV camera systems requiring multi-channel distribution in a single enclosure.

Installation Notes

Installation should be performed by a licensed electrician or qualified low-voltage security technician in accordance with applicable NEC requirements for power-limited and low-voltage wiring. Disconnect and lock out the AC supply before wiring any output channels or making connections inside the enclosure. Verify that the total connected camera load does not exceed the 30-amp rated output to prevent overload conditions. Mount the enclosure in a dry, accessible location to allow for routine inspection and servicing.