Au-ve-co Products 23335 Push Nut M14x25 24mm Od

Product Description

The AU-VE-CO PRODUCTS 23335 is a black push nut designed for use with M14x25 threaded fasteners. Push nuts are one-piece retained fasteners that press onto a threaded screw or stud and lock in place without tools, providing a secure, vibration-resistant hold. This fastener features a 24mm outside diameter and is suited for light-duty retention applications across automotive, HVAC, plumbing, and general mechanical assemblies. It is typically installed by maintenance technicians, assemblers, or field service professionals wherever a quick, tool-free fastener retention solution is needed.

The 23335 push nut is intended for use with M14x25 threaded screws and studs. Its 24mm outside diameter provides a broad seating surface that distributes clamping load evenly against the mating panel or component. Common applications include equipment panels, plastic housings, sheet metal assemblies, and similar installations where a low-profile locking fastener is required. The black finish suits applications where appearance or corrosion resistance on the fastener face is a consideration.

Key Features

• Fits M14x25 threaded screws and studs for secure tool-free retention
• 24mm outside diameter provides broad seating and even load distribution
• Black finish for appearance and basic corrosion resistance
• One-piece push-on design installs without additional hardware or tools
• Suitable for sheet metal, plastic housing, and panel retention applications

Compatibility

Designed for use with M14x25 threaded fasteners across general mechanical, HVAC, plumbing, and industrial assembly applications.

Installation Notes

Push nuts are pressed onto the threaded fastener by hand or with a flat-faced setting tool until the nut seats flush against the mating surface. Ensure the mating panel or substrate is clean and free of burrs before installation. Push nuts are generally considered non-reusable once seated; replace with a new fastener if removal is required. No special certifications or torque specifications are required for standard push nut installation.