Au-ve-co Products 20889 Plastic Push Mount Rivet

Product Description

The AU-VE-CO PRODUCTS 20889 is a plastic push mount rivet designed for securing exterior and underhood trim panels in automotive applications. This fastener uses a push-to-install design that snaps into pre-drilled holes without tools, making it a fast, repeatable solution for panel attachment. The 20889 is constructed from plastic, keeping it lightweight and resistant to corrosion in exposed locations. Automotive technicians, body shop professionals, and fleet maintenance crews commonly use this type of fastener when reinstalling trim components during collision repair or routine service work.

The 20889 is intended for use in cowl vent assemblies, grille panels, fenders, and bumper fascias. These locations see regular removal and reinstallation during service, making a reliable, consistent push mount fastener essential. The push mount design allows for clean, rattle-free attachment without mechanical fastening tools, which speeds up reassembly on production or repair lines. This rivet type is a staple in automotive body and trim service across passenger vehicles and light trucks.

Key Features

• Push mount installation requires no tools for panel reinstallation
• Plastic construction resists corrosion in exposed exterior locations
• Suited for cowl vents, grilles, fenders, and bumper fascias
• Lightweight design does not add measurable load to trim panels
• Consistent snap fit supports rattle-free panel retention

Compatibility

Designed as a push mount trim fastener for cowl vent, grille, fender, and bumper panel applications on automotive vehicles. Refer to your vehicle-specific fastener guide or OEM service manual to confirm hole diameter and retention clip engagement before installation.

Installation Notes

Installation is performed by automotive technicians or body shop professionals as part of trim panel service. Align the rivet stem with the pre-drilled panel hole and apply firm, even hand pressure until the retention tabs engage fully. Inspect the mounting hole for damage or enlargement before installing a new rivet, as a compromised hole will not provide proper retention. No special tools are required for standard push mount installation, though a trim removal tool is recommended for extraction without damaging the panel.