Au-ve-co Products 12115 M4 Push Nut 15mm Od Black

Product Description

The AU-VE-CO PRODUCTS 12115 is a black push nut designed for use with M4 screws and non-threaded fastener applications. With a 15mm outside diameter, this push nut installs by pressing onto an M4 screw shank without requiring threading, providing a secure, low-profile retention point. It is a common hardware component used in HVAC, electrical, and general equipment assembly where a fast, tool-free fastening solution is needed. Weighing just 0.01 pounds per unit, it is a lightweight retention fastener suited for panel, cover, and component securing tasks.

This push nut is used in residential and light commercial equipment assembly, sheet metal fabrication, and control panel construction. It is well suited for applications where a nut cannot be threaded onto a stud or screw and a push-on retention method is required. HVAC technicians, electricians, and equipment assemblers commonly use this type of fastener when securing access panels, wire routing clips, and plastic or sheet metal components to M4 screw posts.

Key Features

• Push-on installation requires no threading - seats directly onto M4 screw shanks
• 15mm outside diameter provides a wide bearing surface for secure panel retention
• Black finish for low-visibility or color-matched applications
• Designed for use with non-threaded fastener assemblies
• Lightweight at 0.01 pounds per unit

Compatibility

Designed for use with M4 screws and non-threaded fastener assemblies in equipment panels, covers, and light fabrication applications.

Installation Notes

Push nuts are typically installed by hand or with a flat-faced press tool - do not use sharp or pointed tools that may deform the retention tabs. Ensure the mating screw or stud is clean and free of burrs before pressing the nut into place. Once seated, push nuts are generally considered a one-time-use fastener and should be replaced rather than reused if removed.