Atg 44-3745/XS Cut Resistant Gloves Xs Ansi A3 Nitrile

Product Description

The ATG 44-3745/XS is a cut-, puncture-, and abrasion-resistant work glove engineered for trade professionals who handle sharp materials, sheet metal, conduit, or rough surfaces on the job. Built on a 15-gauge engineered yarn shell with a seamless lining, the glove delivers ANSI Cut Level A3 and ANSI Puncture Level 2 protection without sacrificing dexterity. The palm and fingers are dipped in MicroFoam nitrile, giving installers a secure grip in light wet or oily conditions while maintaining enough tactile sensitivity for detail work. The nylon-spandex back keeps the fit close and allows full hand movement throughout a shift.

This glove is suited for general trade work in HVAC, electrical, plumbing, and light construction where cut hazards are present but a bulky leather glove would reduce tool control. The touchscreen-compatible palm coating lets technicians use phones or tablets without removing the glove. The reinforced thumb crotch addresses one of the most common wear points in gloves used for wire pulling, pipe handling, and sheet metal work. Appropriate for both residential and light commercial job sites. Sold as a paired set in size XS, fitting both men and women with smaller hand profiles.

Key Features

• ANSI Cut Level A3 and ANSI Puncture Level 2 protection from 15-gauge engineered yarn construction
• ANSI Abrasion Level 3 rated for durability against rough surfaces
• MicroFoam nitrile palm and finger coating for grip in light wet or oily conditions
• Touchscreen-compatible palm for phone and tablet use without glove removal
• Reinforced thumb crotch reduces wear at a high-stress contact point
• Seamless lining and knit slip-on cuff for all-day comfort and easy donning

Compatibility

Designed as a general-purpose cut-resistant work glove for trade professionals requiring ANSI A3 cut protection in size XS. Fits standard XS hand sizing for both men and women.

Installation Notes

Inspect gloves before each use for cuts, tears, or nitrile coating separation that would compromise protection. These gloves are not rated as a blood-borne pathogen barrier and should not be used as a substitute for medical-grade PPE. Always select PPE in accordance with the hazard assessment required by OSHA 1910.138. Replace gloves when the coating shows visible wear or when structural integrity is compromised.