Atg 44-3445/L Cut Resistant Gloves Large Ansi A3 Nitrile

Product Description

The ATG 44-3445/L is a cut-, puncture-, and abrasion-resistant work glove built for trade professionals who need reliable hand protection without sacrificing dexterity. Constructed with a 15-gauge engineered yarn shell and a nitrile dipped coating across the palm and fingers, this glove meets ANSI/ISEA Cut Level A3, Puncture Level 2, and Abrasion Level 4. The MicroFoam grip surface provides reliable hold on both wet and dry surfaces. At 9.25 inches overall length and weighing 0.1 pounds per pair, it is sized for large hands and suitable for all-day wear in demanding job site conditions.

This glove is well suited for residential and commercial trade work including HVAC service, plumbing rough-in, electrical installation, and general mechanical assembly where cut and puncture hazards are present. The seamless engineered yarn lining and breathable construction make it appropriate for extended use. The slip-on knit cuff provides a snug fit at the wrist. It is sold as a paired set and is unisex, fitting men's large or women's medium sizing.

Key Features

• ANSI/ISEA Cut Resistance Level A3 with 15-gauge engineered yarn construction
• ANSI/ISEA Puncture Resistance Level 2 for protection against sharp fasteners and wire ends
• ANSI/ISEA Abrasion Resistance Level 4 for durability on rough surfaces
• Nitrile dipped palm and finger coating with MicroFoam grip surface for wet and dry handling
• Seamless engineered yarn lining for all-day comfort and reduced hand fatigue
• EN 388 rated 4542CX for internationally recognized cut and mechanical protection compliance

Compatibility

Designed as a general-purpose cut-resistant work glove suitable for trade professionals in HVAC, plumbing, electrical, and mechanical service applications requiring ANSI Cut Level A3 hand protection.

Installation Notes

Inspect gloves before each use for tears, punctures, or coating delamination that would reduce protection. Replace immediately if the coating or shell shows signs of damage. These gloves are not rated as a blood-borne pathogen barrier and are not static dissipative. For electrical work, confirm that glove selection meets applicable NFPA 70E or OSHA PPE requirements for the specific hazard level present.