Atg 34-8443/S Cut-resistant Gloves Small Ansi A2 Nitrile

Product Description

The ATG 34-8443/S is a cut-resistant work glove rated ANSI/ISEA Cut Level A2 and designed for trade and industrial applications where hand protection and dexterity are both required. The glove features a 15-gauge seamless engineered yarn liner with nitrile MicroFoam coating applied across the palm and fingers. That dipped coating provides an optimized grip on both wet and dry surfaces while maintaining tactile feel. A reinforced zone between the thumb and forefinger adds durability at the highest-wear contact point. Licensed electricians, HVAC techs, plumbers, and pipe fitters regularly use gloves in this class for parts handling, sheet metal work, and general mechanical service.

The 34-8443/S is sized for men's small or women's extra-small and ships as a paired set. The knit slip-on cuff and 360-degree breathability construction make it suitable for extended wear during residential and light commercial service calls. The green engineered yarn back and cuff offer quick visual identification on the job. The glove carries an EN 388 rating of 4331BX, covering abrasion, cut, tear, and puncture resistance under European standards in addition to the ANSI/ISEA A2 cut and level 4 abrasion ratings.

Key Features

• ANSI/ISEA Cut Resistance Level A2 with ANSI Abrasion Resistance Level 4
• 15-gauge seamless engineered yarn liner for consistent fit and liner penetration control
• Nitrile MicroFoam palm and finger coating for grip on wet and dry surfaces
• Reinforced thumb-to-forefinger saddle for high-wear durability
• 360-degree breathability construction reduces hand fatigue during extended wear
• EN 388 rated 4331BX — meets both ANSI/ISEA and EN388 standards

Compatibility

Designed as an OEM-style paired work glove for trade professionals requiring ANSI Cut Level A2 hand protection in mechanical, HVAC, plumbing, and electrical service environments.

Installation Notes

Inspect gloves before each use for coating separation, tears, or liner damage and replace if compromised. These gloves do not provide arc flash, electrical insulation, or chemical splash protection — verify PPE requirements against the specific hazard before use. Follow applicable OSHA hand protection standards (29 CFR 1910.138) when selecting and using cut-resistant gloves on the job.