Atg 34-1743/XS Cut Resistant Gloves Xs Ansi A4 Nitrile

Product Description

The ATG 34-1743/XS is a cut, puncture, and abrasion resistant work glove rated ANSI/ISEA Cut Level A4 and ANSI/ISEA Abrasion Level 3, built for trade professionals who work around sharp edges, sheet metal, glass, or rough materials. The shell is constructed from a 15-gauge blend of Kevlar, nylon, and polyester with a seamless lining for all-day comfort. The palm and fingers are dipped in MicroFoam nitrile for grip on both dry and slightly oily surfaces. The glove is sized XS and weighs 0.17 pounds per pair. A knit slip-on cuff keeps the fit secure without restricting wrist movement.

This glove is suited for HVAC sheet metal work, plumbing rough-in, electrical conduit handling, and general mechanical service where cut hazards are present but dexterity cannot be sacrificed. The nitrile MicroFoam coating provides grip without adding significant bulk, making it practical for fastener work, pipe handling, and tight-clearance tasks. The Kevlar and polyester back construction adds cut protection across the full hand. The glove is silicone-free, which is important in environments where silicone contamination can cause paint or coating adhesion failures.

Key Features

• ANSI/ISEA Cut Resistance Level A4 with EN 388 Rating 4331D
• ANSI/ISEA Abrasion Resistance Level 3 for extended wear against rough surfaces
• ANSI/ISEA Puncture Resistance Level 1
• 15-gauge seamless Kevlar, nylon, and polyester lining for comfort and dexterity
• MicroFoam nitrile palm and finger coating for optimized grip on varied surfaces
• Silicone-free construction suitable for finishing and coating work environments
• Unisex XS sizing with knit slip-on cuff for a secure, adjustable fit

Compatibility

Designed as a general-purpose cut-resistant work glove for trade professionals in HVAC, plumbing, electrical, and mechanical service applications requiring ANSI Cut Level A4 hand protection.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that could compromise protection. These gloves are rated for cut and abrasion resistance but are not rated as a blood-borne pathogen barrier and should not be used as a substitute for chemical-resistant or liquid-tight PPE where required. Replace gloves when the nitrile coating shows visible wear or delamination. Consult applicable OSHA and jobsite PPE requirements to confirm this protection level meets task-specific hazard assessments.