Atg 19-D470/L Cut Resistant Gloves Size L Ansi A4

Product Description

The ATG 19-D470/L is a cut-, puncture-, and abrasion-resistant work glove designed for trade professionals who handle sharp materials, sheet metal, glass, or other high-hazard surfaces. Constructed with a Dyneema liner at 13-gauge and coated with nitrile MicroFoam on the palm and fingers, this glove meets ANSI/ISEA Cut Level A4, Puncture Level 3, and Abrasion Level 3 ratings. The seamless Dyneema lining reduces interior seam irritation during extended wear. The dipped nitrile MicroFoam coating provides grip on both dry and lightly oily surfaces, making it practical for HVAC sheet metal work, plumbing rough-in, and general mechanical trades. Overall length is 9 inches. Sold as a pair.

This glove is sized Large for men and Medium for women, making it a unisex fit across a range of hand sizes. The slip-on knit cuff and seamless lining allow for quick donning and removal between tasks. The gray Dyneema shell and gray cuff are part of the 19-D470 series. These gloves are suited for residential and light commercial installation environments where cut and puncture protection is required without sacrificing dexterity. They are not rated as a blood-borne pathogen barrier and are not FDA approved for sterile or food-contact applications.

Key Features

• ANSI/ISEA Cut Resistance Level A4 for protection against sharp edges and sheet metal
• ANSI/ISEA Puncture Resistance Level 3 for protection against wire, fasteners, and sharp protrusions
• ANSI/ISEA Abrasion Resistance Level 3 with EN 388 rating of 4443DX
• Nitrile MicroFoam dipped coating on palm and fingers for dry and light-oil grip
• 13-gauge seamless Dyneema lining for dexterity and comfort during extended use
• Slip-on knit cuff for fast donning in busy install environments

Compatibility

Designed as a general-purpose cut- and puncture-resistant glove for trade professionals in HVAC, plumbing, electrical, and mechanical service applications where ANSI Cut Level A4 protection is required.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating delamination that may compromise protection ratings. These gloves are not a substitute for arc flash, chemical, or electrical insulation PPE. Replace when coating shows visible wear or when the liner is damaged. Consult applicable OSHA hand protection standards and jobsite PPE requirements before use.