Associated Spring Raymond W5408053 Triple Wave Washer

Product Description

The ASSOCIATED SPRING RAYMOND W5408053 is a triple wave washer engineered for applications requiring controlled axial load and deflection in mechanical assemblies. Constructed from 1074 grade steel, this washer delivers a load at deflection of 162 pounds, making it suited for preloading bearings, taking up end play, and maintaining consistent spring force in rotating or reciprocating equipment. With an outside diameter of 5.408 inches, an inside diameter of 4.208 inches, and an overall height of 0.388 inches, the W5408053 fits larger-bore assemblies where precise spring force is critical. Installation is typically performed by mechanical technicians and millwrights working on industrial or commercial equipment.

This triple wave washer is designed for use in mechanical systems where a repeatable, low-profile spring element is needed to absorb shock, reduce vibration, or maintain preload over the service life of the assembly. Its wave geometry distributes load evenly across three contact points, reducing stress concentration compared to single-wave designs. Typical install scenarios include motor end caps, gearbox assemblies, pump housings, and bearing retainer applications where dimensional tolerances demand a thin, consistent spring element. The 1074 steel construction provides the hardness and fatigue resistance required for cyclic loading environments.

Key Features

• Triple wave geometry distributes axial load evenly across three contact points
• 162 lb load at deflection for reliable preload in bearing and retainer assemblies
• 1074 grade steel construction for fatigue resistance under cyclic loading
• Low-profile design at 0.388 inches overall height suits tight axial clearances
• 5.408 inches OD and 4.208 inches ID fit large-bore mechanical assemblies
• 0.053 inches material thickness provides consistent spring rate

Compatibility

Designed as an OEM-style replacement or drop-in spring element for large-bore mechanical assemblies requiring a triple wave washer with a 5.408 inch outside diameter and 4.208 inch inside diameter.

Installation Notes

Installation is performed by qualified mechanical technicians or millwrights. De-energize and lock out all power to the equipment before disassembling any bearing housing or end cap. Ensure mating bore and shaft surfaces are clean and free of burrs before seating the washer. Do not stack multiple wave washers unless the assembly design specifically calls for it, as doing so alters the spring rate and load characteristics.