Associated Spring Raymond 206-614 Die Spring Extra Strong

Product Description

The ASSOCIATED SPRING RAYMOND 206-614 is an extra-strong die spring designed for use in stamping dies, press tooling, and similar high-cycle industrial applications. It features a 32.00 mm hole diameter, a 16.00 mm rod diameter, and a free length of 3-1/2 inches (89.00 mm). Constructed from chromium alloy steel with a trapezoidal wire cross-section, this spring delivers a maximum deflection load of 3966.60 N and a maximum deflection of 22.00 mm. The yellow color coding identifies it as an extra-strong duty rating per ISO 10243 standards. It is suited for installation by tool and die makers, maintenance technicians, and press room professionals.

This die spring fits standard die sets and press tooling that require an extra-strong force class spring with a 32.00 mm bore. The 3-1/2 inch free length and 16.00 mm rod diameter make it a direct fit in applications where space constraints and load requirements align with the extra-strong duty class. It is commonly used in metal stamping operations, injection mold tooling, and industrial punch press setups where consistent, repeatable spring force is critical to die performance and part quality.

Key Features

• Extra-strong duty rating with a maximum deflection load of 3966.60 N
• Trapezoidal wire cross-section for higher load capacity versus round-wire springs of the same envelope size
• Chromium alloy steel construction for fatigue resistance under high-cycle conditions
• Yellow color coding for quick identification of extra-strong duty class per ISO 10243
• Spring rate of 1029.54 N/mm for predictable, linear deflection behavior
• Manufactured under ISO 9001:2008 and ISO/TS 16949:2009 certified quality systems with TUV Rheinland registration

Compatibility

Designed as an ISO 10243-compliant extra-strong die spring for standard die sets and press tooling with a 32.00 mm hole diameter and 16.00 mm rod diameter.

Installation Notes

Die spring replacement and installation should be performed by qualified tool and die makers or maintenance technicians with the press fully de-energized and all stored energy safely discharged before disassembly. Inspect the mating bore and guide rod for wear or damage before fitting the new spring. Do not compress the spring beyond its rated maximum deflection of 22.00 mm to avoid permanent set or premature failure. Follow applicable plant safety procedures and tooling manufacturer guidelines during installation.