Apollo Valves 670750406331 Ball Valve 1/2 in Fnpt 600 Psi

Product Description

The APOLLO VALVES 670750406331 is a 2-piece, 1/2 inch FNPT ball valve from the 70-100 Series, designed for reliable shut-off service in commercial and industrial piping systems. It features a bronze body with a chrome plated brass ball, brass stem, and PTFE seat trim, rated for 600 psi cold working pressure (CWP) and up to 500 degrees F. The standard port design and latch-lock oval handle actuator provide straightforward quarter-turn operation and tamper resistance. This is a domestically manufactured valve suitable for a wide range of plumbing, mechanical, and HVAC hydronic applications.

This valve is intended for use in residential and light commercial systems where a dependable, full-quarter-turn shut-off is required on 1/2 inch threaded pipe runs. Female NPT end connections on both sides allow direct threaded installation into existing pipe without adapters. The latch-lock oval handle resists accidental repositioning, making it well suited for service isolation, branch control, and maintenance shutoff points. Licensed plumbers and mechanical contractors are the primary installers of this valve in hot and cold water, steam, and hydronic heating applications.

Key Features

• Bronze body construction rated to 600 psi CWP for durable, corrosion-resistant service
• Temperature rating up to 500 degrees F suits steam and high-temperature hydronic systems
• Chrome plated brass ball with PTFE seat and RMPTFE softgoods for low-torque, leak-tight shutoff
• Latch-lock oval handle prevents unintended valve actuation
• Female NPT (FNPT) end connections on both inlet and outlet for standard threaded installation
• Domestically manufactured with a 5-year warranty

Compatibility

Designed as an OEM-style 2-piece bronze ball valve replacement for 1/2 inch FNPT threaded piping systems. Manufacturer Part Numbers 701034147 and 70-103-41-47 are associated with this valve within the Apollo 70-100 Series.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local plumbing codes and ASME standards. Shut off and depressurize the system completely and allow it to cool before removing or installing any valve. Apply thread sealant or PTFE tape to male threads before making up connections, and avoid over-tightening, which can crack the valve body. Do not exceed the stated pressure or temperature ratings.