Apex 49-TX-25 T25 Torx Power Screwdriver Bit 1/4 Inch Hex

Product Description

The APEX 49-TX-25 is a T25 Torx power screwdriver bit designed for use with 1/4 inch hex drive power tools and bit holders. It has an overall length of 1-15/16 inches and a body diameter of 0.19 inches (4.90 mm). Built for powered applications, this bit delivers consistent torque transfer on T25 Torx fasteners commonly found in HVAC equipment panels, electrical enclosures, and mechanical assemblies. Electricians, HVAC technicians, and service pros who regularly work with Torx fasteners will find this a direct fit for standard impact drivers and power screwdrivers with a 1/4 inch hex chuck.

This bit is suited for service and installation work across residential and light commercial applications where T25 Torx fasteners are specified. It is commonly used when servicing equipment cabinets, control panels, and access covers that use Torx hardware. The 1-15/16 inch overall length fits most standard power bit holders and quick-change magnetic bit holders without modification.

Key Features

• T25 Torx tip fits standard T25 Torx fasteners used in equipment panels and enclosures
• 1/4 inch hex drive shank is compatible with power screwdrivers, impact drivers, and quick-change bit holders
• 1-15/16 inch overall length fits standard power tool bit holders
• Body diameter of 0.19 inches (4.90 mm) for consistent fit in confined fastener recesses
• Single-piece package — sold individually for targeted replacement or kit supplementing

Compatibility

Designed for use with any 1/4 inch hex drive power screwdriver, impact driver, or bit extension holder that accepts standard power bits. Fits T25 Torx fasteners as used in HVAC equipment cabinets, electrical panels, and similar trade hardware.

Installation Notes

Installation and use of this bit requires a compatible 1/4 inch hex drive power tool or manual bit holder. Always ensure power tools are set to an appropriate torque setting to avoid stripping T25 Torx fasteners. Confirm the fastener head is fully seated against the bit tip before applying drive force to prevent cam-out. De-energize any electrical equipment before servicing fastened panels or covers in accordance with NFPA 70E lockout/tagout procedures.