Anvil 0560018855 Extension Split Pipe Clamp 1-1/2 Inch

Product Description

The ANVIL 0560018855 is a malleable iron extension split pipe clamp rated for 1-1/2 inch nominal pipe size with a 180 lb load capacity. Split clamp designs allow installation and removal without disconnecting the pipe run, making them a practical choice for suspended piping systems in mechanical rooms, utility spaces, and commercial buildings. The blue and silver finish provides corrosion resistance for typical indoor piping environments. Licensed pipefitters, plumbers, and mechanical contractors install this type of clamp when supporting horizontal pipe runs from threaded rod hanger assemblies.

This extension split pipe clamp is suited for use in residential and commercial plumbing, HVAC piping, and general mechanical piping support applications. It accommodates 1-1/2 inch nominal pipe and accepts 3/8 inch threaded rod, making it compatible with standard pipe hanger assemblies used in suspended ceiling and overhead piping installations. The extension style provides additional clearance between the pipe and the supporting structure where standard clamps do not offer sufficient standoff depth.

Key Features

• Split clamp design allows installation on existing pipe without disconnecting the line
• 180 lb load capacity supports standard suspended piping loads
• Malleable iron construction provides strength and durability for mechanical piping environments
• Accepts 3/8 inch diameter threaded rod for compatibility with common hanger assemblies
• Extension style adds standoff clearance between pipe and structural support
• Blue and silver finish for identification and basic corrosion resistance in indoor applications

Compatibility

Designed for use with 1-1/2 inch nominal pipe and 3/8 inch threaded rod hanger systems in standard commercial and residential mechanical piping installations.

Installation Notes

Installation is typically performed by licensed plumbers or mechanical contractors following applicable IPC and IFGC support spacing requirements. Shut down and depressurize the piping system before modifying any hanger or support. Ensure the threaded rod and structural attachment point are rated to handle the combined load of the pipe, fluid, and any additional hangers sharing the support. Verify that the clamp is fully seated and fasteners are snug before returning the system to service.