Anvil 0332825405 Black Pipe Nipple 1-1/4 in Sch 160

Product Description

The ANVIL 0332825405 is a Schedule 160 black pipe nipple sized at 1-1/4 inches in diameter and 5 inches in length. This close-tolerance threaded fitting is used to connect sections of pipe or to extend a run within a piping system. The heavy-wall Schedule 160 construction provides significantly greater pressure and impact resistance than standard Schedule 40 fittings, making it suitable for demanding industrial, mechanical, and high-pressure service applications. The black finish coat protects against corrosion during storage and installation. Plumbers, pipefitters, and mechanical contractors install this type of nipple as part of threaded steel piping assemblies.

This pipe nipple is a standard component in threaded black steel piping systems used in gas distribution, steam, fire suppression, and industrial fluid service. Schedule 160 wall thickness is specified when elevated operating pressures or mechanical abuse demands more than standard weight fittings can provide. It fits into systems wherever a short-run threaded male connection is needed between fittings, valves, or equipment ports with a 1-1/4-inch NPT connection.

Key Features

• Schedule 160 heavy wall for high-pressure piping service
• 1-1/4 inch nominal pipe size with standard NPT threads on both ends
• 5 inch overall length for short-run connections
• Black finish coating provides corrosion protection
• Threaded both ends for direct installation into fittings, valves, or equipment ports

Compatibility

Designed as an OEM-style replacement and standard-use component for 1-1/4-inch NPT threaded black steel piping systems in Schedule 160 applications.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable code requirements, including IFGC or IPC where relevant. Shut off and depressurize the piping system completely before removing or installing any threaded fitting. Apply a code-approved thread sealant or pipe-thread tape to the male threads before assembly. Do not over-torque threaded connections, as this can crack fittings or damage threads.