Ansell 48707110 Cut Resistant Gloves A6 2x-large

Product Description

The ANSELL 48707110 is a cut, puncture, and abrasion-resistant knit work glove from the EDGE 48-707 series, designed for trade and industrial professionals who work around sharp materials, sheet metal, glass, or jagged components. Built from a 13-gauge blend of polyester, fiberglass, spandex, nylon, and HPPE, the glove achieves an ANSI/ISEA Cut Resistance Level of A6 and a Puncture Resistance Level of 4. A polyurethane coating covers the palm, delivering grip and tactile sensitivity. Overall length is 10.625 inches. Licensed HVAC techs, sheet metal workers, plumbers, and electricians handling conduit, pipe, or duct work commonly use this glove class.

This glove is suited for both residential and light commercial applications where workers handle sharp-edged materials during installation or service. The 2X-Large sizing accommodates larger hands, and the hand-specific construction ensures a secure, low-bulk fit on each hand. The knit cuff with light blue trim allows quick size identification in a job-site glove bin. The sandy grip surface maintains control on wet or oily surfaces, making it practical across HVAC, plumbing, electrical, and general construction trades.

Key Features

• ANSI/ISEA Cut Resistance Level A6 for protection against sharp sheet metal, glass, and edged materials
• ANSI/ISEA Puncture Resistance Level 4 for added protection against pointed fasteners and wire ends
• ANSI/ISEA Abrasion Resistance Level 5 rated shell construction
• 13-gauge polyester, fiberglass, spandex, nylon, and HPPE blend shell for dexterity and cut protection
• Polyurethane palm coating with sandy grip surface for wet and dry surface control
• Hand-specific design for reduced hand fatigue during extended wear
• EN 388 Rating: 4X43F for internationally recognized mechanical risk verification

Compatibility

Designed as an OEM-style replacement or direct-use work glove within the ANSELL EDGE 48-707 series. Sized as 2X-Large (Numeric Size 11) and suitable for unisex fit in that hand size range.

Installation Notes

This glove is worn by the technician, not installed in a system. Inspect gloves before each use for tears, coating separation, or compromised shell integrity. Replace immediately if the shell or coating shows damage that could reduce cut or puncture protection. Follow applicable OSHA hand protection requirements (29 CFR 1910.138) when selecting gloves for specific hazard levels on the job site.