Ansell 285221 Cut-resistant Gloves 2XL Ansi A5 Nitrile

Product Description

The ANSELL 285221 is a high-visibility, cut-resistant work glove from the 11-515 series, designed for trade and industrial applications where hand protection against cuts, abrasion, and puncture hazards is required. The glove shell is constructed from a 13-gauge blend of Kevlar, Spandex, and Stainless Steel with a seamless lining for consistent fit and reduced irritation. A foam nitrile dipped coating covers the palm and fingertips, delivering a secure grip on both wet and dry surfaces. Static dissipative properties are built into the construction. This glove is sized for 2X-Large men or 3X-Large women and is sold as a pair.

The 285221 is suited for use in HVAC sheet metal work, mechanical assembly, plumbing rough-in, electrical conduit handling, and light fabrication tasks where EN 388 and ANSI cut-level compliance is required. The lime yellow and orange colorway provides job-site visibility. The knit cuff provides a snug, debris-resistant fit at the wrist. This glove meets ANSI/ISEA A5 cut resistance and ANSI abrasion resistance level 4, making it appropriate for tasks involving sharp edges, metal components, or abrasive materials. It is not FDA approved and does not provide a blood-borne pathogen barrier.

Key Features

• ANSI/ISEA Cut Resistance Level A5 with EN 388 rating of 4X42E
• 13-gauge Kevlar, Spandex, and Stainless Steel shell with seamless lining
• Foam nitrile dipped coating on palm and fingertips for grip on wet and dry surfaces
• Static dissipative construction for use near sensitive electrical components
• High-visibility lime yellow and orange coloring for job-site awareness
• ANSI/ISEA Abrasion Resistance Level 4 knit cuff for secure wrist fit

Compatibility

Designed as an OEM-compatible replacement or direct-purchase option for workers requiring ANSI A5 cut-resistant gloves in trade, industrial, and mechanical service environments. Fits men's 2X-Large or women's 3X-Large hand sizing per ANSELL 11-515 series sizing charts.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating delamination that would reduce protection. Gloves should be donned before handling sheet metal, conduit, or any sharp-edged components. Always follow applicable OSHA 29 CFR 1910.138 personal protective equipment standards for hand protection selection. Damaged or worn gloves must be replaced immediately and not repaired.