Ansell 245715 Cut-resistant Leather Gloves Large

Product Description

The ANSELL 245715 is a puncture-resistant, cut-resistant work glove built for trade professionals who work with sharp materials, wire, sheet metal, or abrasive surfaces. Constructed with a leather coating and an acrylic and nylon seamed lining, these gloves deliver ANSI Abrasion Level 5 performance and an EN 388 rating of 4443. The plaited construction adds structural integrity across the palm and fingers. The knit cuff provides a snug, secure fit at the wrist to reduce debris intrusion during use. Sold as a pair in size Large, they also fit women wearing X-Large. At 0.3 pounds per pair, they are lightweight enough for extended wear on the job.

These gloves are suited for residential and commercial trade applications including HVAC sheet metal handling, plumbing rough-in work, electrical conduit bending, and general mechanical service tasks. Any task involving metal edges, strapping, wire pulls, or abrasive materials is a typical use case. The gray colorway and uncoated finish keep them versatile across job site conditions. The ANSI Cut classification is listed as N/A under ANSI/ISEA cut resistance for this series, with protection performance certified under the EN 388 4443 standard.

Key Features

• Leather construction provides puncture and abrasion resistance rated ANSI Abrasion Level 5
• EN 388 4443 certified for cut, abrasion, tear, and puncture protection
• Acrylic and nylon seamed lining for comfort during extended wear
• Plaited construction reinforces glove integrity across high-contact areas
• Knit cuff style for secure wrist fit and debris reduction
• Sold as a pair, uncoated finish, static non-dissipative

Compatibility

Sized for men wearing Large or women wearing X-Large. Part of the ANSELL Series 70-765. Designed as an OEM-style replacement or direct procurement glove for trade professionals requiring EN 388-rated hand protection.

Installation Notes

Inspect gloves before each use for cuts, tears, or lining separation that could reduce protection. These gloves do not provide electrical insulation and must not be used as primary protection against electrical hazards. Replace immediately if the leather shows signs of puncture, cracking, or structural failure. Follow applicable OSHA hand protection standards and site-specific PPE requirements when selecting and using cut-resistant gloves.