Ansell 206490 Flame Resistant Gloves Size M 9.4 Cal

Product Description

The ANSELL 206490 is a pair of flame resistant, arc flash protection gloves designed for electrical workers and industrial tradespeople who face arc flash and heat exposure hazards on the job. The glove shell is constructed from KEVLAR with a neoprene coating applied to the palm, providing cut resistance at ANSI/ISEA Level A4 and abrasion resistance at Level 3. Maximum arc flash protection is rated at 9.4 cal/sq cm, making these gloves appropriate for low-to-moderate arc flash PPE categories as defined under NFPA 70E. The knit cuff and ergonomic fit support extended wear during electrical service, panel work, and switchgear maintenance tasks.

These gloves are suited for licensed electricians, maintenance technicians, and industrial tradespeople working in environments where arc flash and flame hazards are present. Typical applications include commercial and industrial electrical maintenance, panel inspections, and any task requiring compliance with NFPA 70E arc flash PPE requirements. The medium size fits both men's and women's sizing in a numeric size 8, and the pair is sold as a single set. The static dissipative construction adds a secondary benefit in environments sensitive to electrostatic discharge.

Key Features

• Arc flash protection rated to 9.4 cal/sq cm maximum
• KEVLAR lining with neoprene palm coating for cut and abrasion resistance
• ANSI/ISEA Cut Resistance Level A4 and Abrasion Resistance Level 3
• Static dissipative construction
• Knit cuff style for secure, comfortable fit
• Ergonomic design with soft foam coating for extended wear

Compatibility

Designed for use in arc flash and flame hazard environments requiring compliance with ANSI S11.11, NFPA 70E, and CGSB 155.20-2000 standards. Sold as a pair in size medium.

Installation Notes

Gloves should be inspected before each use for cuts, tears, coating degradation, or contamination that could compromise arc flash protection. Follow your site arc flash hazard analysis and NFPA 70E PPE category requirements to confirm these gloves are appropriate for the specific incident energy level of the task. Do not use in place of rated electrical insulating gloves where voltage-rated protection is required. Replace immediately if the glove shows signs of damage or has been exposed to an arc flash event.