Ansell 11755060 Cut-resistant Gloves Ansi A5 X-small

Product Description

The ANSELL 11755060 is an ANSI Cut Level A5, 18-gauge cut-resistant glove designed for trade and industrial applications where hand protection against sharp edges and abrasion is required. The glove shell is constructed from a blended HPPE, tungsten steel, spandex, and polyester yarn, delivering ultralight cut resistance rated to ANSI/ISEA A5 and EN ISO E-level. The palm and fingertips are dipped in polyurethane for smooth-grip dexterity on fine parts handling. ANSI Abrasion Resistance is rated at Level 4. The seamless lining and knit cuff construction keep the profile low-bulk, and the static-dissipative build suits ESD-sensitive environments. Licensed electricians, HVAC technicians, plumbers, and sheet-metal workers handling ductwork, conduit, copper tubing, and similar sharp materials are the primary users.

The 11755060 is suited for light to moderate-duty tasks in residential and commercial trade work where tactile feedback and cut protection must coexist. Typical applications include handling sheet metal during ductwork fabrication and installation, manipulating copper fittings and tubing, pulling wire and cable through conduit, and general parts handling on service calls. The glove is unisex and sized X-Small, making it a practical stock item for shops that outfit technicians of varying hand sizes. Touchscreen compatibility allows use with tablets and phones without removing the glove, which is useful on job sites where digital work orders are standard.

Key Features

• ANSI/ISEA Cut Resistance Level A5 and EN 388 Rating 3X41E for verified cut protection
• 18-gauge HPPE, tungsten steel, spandex, and polyester shell provides ultralight construction without sacrificing protection
• Polyurethane dipped palm and fingertips deliver smooth grip and enhanced dexterity for fine-parts handling
• Static-dissipative construction suitable for ESD-sensitive electrical and electronics work
• Seamless lining and knit cuff reduce bulk and pressure points during extended wear
• Touchscreen-compatible fingertips allow device use without glove removal

Compatibility

Designed as an OEM-style replacement or direct stock glove within the ANSELL 11-755 Series. Part of the Series 11-755 cut-resistant glove line and sized for X-Small hands.

Installation Notes

Inspect gloves prior to each use for cuts, tears, or coating separation that would reduce protection. These gloves are intended for cut and abrasion hazards only and do not provide arc flash, high-voltage electrical insulation, or chemical splash protection. Follow applicable OSHA 29 CFR 1910.138 personal protective equipment requirements when selecting hand protection for a specific task hazard. Replace gloves when the coating shows wear or when cut resistance integrity is in question.