Anderson Metals Corp 38300-1250 Red Brass Pipe Nipple

Product Description

The ANDERSON METALS CORP 38300-1250 is a red brass pipe nipple measuring 3/4 inch in diameter by 5 inches in length. Red brass alloy offers superior corrosion resistance compared to standard yellow brass, making this nipple well suited for water distribution, plumbing supply lines, and other fluid-handling systems. The part meets lead-free requirements under California AB-1953 and Vermont SB-152 legislation, making it compliant for potable water installations. Plumbers and pipefitters install this nipple to connect threaded pipe sections, extend runs, or adapt fittings in both residential and light commercial systems. It is sold in bulk packs of 5 units.

This nipple is used in threaded pipe assemblies where a short, rigid male-threaded connector is required between two fittings or valves. Typical applications include potable water supply lines, hydronic heating systems, and general plumbing rough-in work. Its lead-free certification makes it appropriate for any installation governed by California or Vermont lead-content statutes, as well as the federal Safe Drinking Water Act requirements for fixtures and fittings in contact with potable water. Licensed plumbers working on water service, distribution, or fixture supply branch lines will find this a direct-fit threaded component.

Key Features

• Red brass construction for enhanced corrosion resistance in water and fluid service
• Lead-free compliant per California AB-1953 and Vermont SB-152 legislation
• 3/4 inch nominal diameter with 5 inch lay length for precise pipe run extensions
• Male NPT threads on both ends for standard threaded fitting connections
• Sold in bulk quantity of 5 units per package

Compatibility

Designed as an OEM-style replacement or new-installation component for 3/4 inch NPT threaded plumbing systems requiring lead-free brass pipe nipples in potable water or fluid-handling applications.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Shut off the water supply and relieve system pressure before removing or installing any threaded pipe components. Apply an approved thread sealant or PTFE tape to the male threads before assembly; do not overtighten, as red brass threads can be damaged by excessive torque. Inspect threads for damage before installation to ensure a leak-free joint.

WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.