Anderson Metals Corp 00560-06 Compression Sleeve 3/8 in

Product Description

The ANDERSON METALS CORP 00560-06 is a 3/8-inch plastic compression sleeve designed for use with polyethylene tubing connections. This sleeve fits inside a standard compression fitting assembly, providing the internal support needed to create a secure, leak-resistant joint without deforming soft plastic tubing under compression load. It is a bulk-packaged fitting component used by plumbers, irrigation technicians, and water treatment installers working with polyethylene supply or distribution lines. The part ships in a package quantity of 25 units, making it practical for service vans or job-site restocking.

This compression sleeve is suited for residential and light commercial applications where polyethylene tubing is the pipe material of choice — including underground water service lines, well water distribution systems, drip irrigation laterals, and point-of-use water treatment hookups. The sleeve is installed inside the tubing end before the compression nut and ferrule are applied, preventing the fitting body from collapsing the soft tubing wall as the nut is tightened. It is a standard consumable component kept on hand by plumbers and irrigation contractors who regularly work with poly tubing systems.

Key Features

• 3/8-inch nominal size matches standard compression fittings for polyethylene tubing
• Plastic construction resists corrosion in wet or buried service environments
• Internal support sleeve prevents tubing collapse during compression fitting assembly
• Bulk pack of 25 units per package reduces per-unit cost for high-volume service work
• Compatible with compression-style fitting assemblies used on poly tubing runs

Compatibility

Designed as an OEM-style replacement and standard-stock insert sleeve for 3/8-inch compression fittings used with polyethylene tubing in plumbing, irrigation, and water treatment applications.

Installation Notes

Installation is performed by licensed plumbers or qualified irrigation technicians following applicable plumbing codes such as the IPC. Before servicing any pressurized line, shut off the water supply and relieve line pressure completely. Insert the sleeve fully into the cut end of the polyethylene tubing before seating the tubing into the compression fitting body — do not attempt to install the sleeve after the nut has been partially tightened. Hand-tighten the compression nut first, then snug with a wrench; avoid over-tightening, which can crack plastic fitting components.