Anderson Metals 756206-060604 Brass Tee Reducer Npt

Product Description

The ANDERSON METALS 756206-060604 is a lead-free brass tee reducer fitting designed for threaded NPT piping systems. It transitions between a 3/8-inch run and a 1/4-inch branch, making it a practical solution for splitting or reducing flow in tight plumbing and gas distribution assemblies. Rated to 1,000 psi, this fitting handles the pressure demands of both low-pressure and moderate-pressure systems. The all-brass construction resists corrosion and holds up in continuous-service environments. Licensed plumbers, HVAC technicians, and gas service pros install this type of fitting during new construction, system modifications, and repair work where a threaded tee reduction is required.

This fitting is rated for use with potable water, grease, fuels, LP gas, and natural gas, covering a broad range of residential and light commercial applications. The NPT threaded end connections make it compatible with standard pipe and fitting stock carried by most trade suppliers. It is well suited for gas branch lines, water supply rough-in work, lubrication systems, and fuel distribution plumbing where a tee configuration with a reduced outlet is needed.

Key Features

• Lead-free brass construction meets potable water safety requirements
• 1,000 psi pressure rating supports a wide range of service conditions
• NPT threaded connections on all three ports for standard compatibility
• Tee configuration with 3/8-inch run and 1/4-inch branch outlet
• Approved for potable water, LP gas, natural gas, fuels, and grease service

Compatibility

Designed for use with potable water, grease, fuels, LP gas, and natural gas systems using standard NPT threaded pipe connections.

Installation Notes

Installation should be performed by a licensed plumber or qualified gas technician in accordance with applicable local codes, the IPC, or the IFGC depending on the service fluid. Shut off the water or gas supply and relieve system pressure completely before disassembling any threaded connections. Apply an appropriate thread sealant or PTFE tape rated for the service fluid before threading the fitting into place. Do not overtighten brass fittings, as the material is softer than iron and can be damaged by excessive torque.