Anderson Metals 756110-1606 Pipe Bushing Mnpt X Fnpt

Product Description

The ANDERSON METALS 756110-1606 is a lead-free brass pipe bushing designed to reduce a 1-inch male NPT connection down to a 3/8-inch female NPT port. It carries a maximum working pressure of 1000 psi, making it suitable for demanding plumbing, gas, and fluid-handling applications. The MNPT x FNPT configuration allows direct threaded installation into standard pipe fittings and equipment ports. Plumbers, pipefitters, and HVAC technicians install this bushing when downsizing pipe connections in tight assemblies. The lead-free brass construction meets potable water compliance requirements and resists corrosion across a broad range of media.

This bushing is rated for use with potable water, grease, fuels, and LP and natural gas systems. It is well suited for residential and light commercial plumbing rough-in, gas line distribution manifolds, and hydraulic or pneumatic sub-assemblies where a size reduction is needed at a threaded port. The standard NPT thread form ensures broad fitment across common pipe, valve, and manifold hardware found in trade installations.

Key Features

• Reduces 1-inch MNPT to 3/8-inch FNPT in a single fitting
• 1000 psi maximum working pressure rating
• Lead-free brass construction meets potable water requirements
• Compatible with potable water, grease, fuels, LP gas, and natural gas
• Standard NPT threads for broad compatibility with pipe and valve hardware

Compatibility

Rated for use with potable water, grease, fuels, LP gas, and natural gas systems. Designed as a standard MNPT x FNPT threaded pipe bushing for use wherever a 1-inch male NPT to 3/8-inch female NPT reduction is required in plumbing, gas, or fluid-handling assemblies.

Installation Notes

Installation is performed by a licensed plumber or pipefitter following applicable IPC or IFGC code requirements for the media involved. Shut off and depressurize the line before installing or removing threaded fittings. Apply a code-approved thread sealant or PTFE tape to the male threads before assembly. Do not overtighten; use a pipe wrench with proper jaw protection to avoid deforming the fitting body.