Anderson Metals 750064-04 Compression Tube Union Tee

Product Description

The ANDERSON METALS 750064-04 is a lead-free brass compression tube union tee designed for joining three compression lines at a single fitting point. It accepts 7/16-24 straight thread connections on all three ports and is rated for a maximum working pressure of 3000 psi. The tee configuration allows a main line to branch without requiring additional adapters or fittings. Plumbers and pipefitters install this fitting in applications where a clean, leak-resistant compression joint is required and solder or flare connections are not practical. Its lead-free brass construction meets requirements for use in potable water systems.

This fitting is suited for residential and light commercial plumbing, refrigeration tubing, and hydraulic or pneumatic line applications where compression-style end connections are specified. The tee shape makes it a practical choice for branching a supply line to serve two downstream points from a single source. All three ports share the same 7/16-24 thread specification, simplifying parts selection when all connections in a run are the same size.

Key Features

• Lead-free brass construction suitable for potable water service
• Compression x Compression x Compression end connections on all three ports
• 7/16-24 straight thread on all ports
• Rated to 3000 psi maximum working pressure
• Tee fitting shape for three-way line branching
• Single-piece unit — no additional adapters required at the union point

Compatibility

Designed as an OEM-style replacement or new-installation compression tube union tee for systems using 7/16-24 compression-style fittings in plumbing, refrigeration, or fluid-transfer applications.

Installation Notes

This fitting is installed by licensed plumbers or qualified pipefitters following applicable IPC and local plumbing code requirements. Shut off and depressurize the supply line completely before removing any existing fitting or connecting this union tee. Hand-tighten compression nuts first, then use a wrench to snug — do not overtorque compression fittings, as over-tightening can deform the ferrule and cause leaks. Inspect all three ports for leaks after restoring pressure.