Anderson Metals 738108-06 Brass Pipe Cap 3/8 Inch

Product Description

The ANDERSON METALS 738108-06 is a low-lead threaded pipe cap in rough brass, designed to close off the end of a threaded pipe run. It is manufactured from Alloy No. C84400 brass per ASTM B584 and meets ANSI/ASME B16.15 and ANSI B1.20.1 thread standards. Rated at 125 WSP and 200 WOG, it handles typical working pressures found in residential and light commercial plumbing, hydronic, and gas distribution systems. Lead content on wetted surfaces is held to no more than 0.25% weighted average, satisfying California AB 1953 and Vermont SB 152 low-lead requirements. Plumbers and pipefitters install this cap to terminate or pressure-test threaded pipe lines.

This cap is appropriate for use in residential and commercial plumbing systems wherever a threaded pipe end requires a secure, leak-free closure. Common applications include capping off unused branch outlets, isolating sections of a supply line during renovation, and serving as a test point plug during pressure testing. Its compliance with WW-P-460 Federal Specifications makes it suitable for a broad range of plumbing and mechanical installations requiring conformance to recognized industry standards.

Key Features

• Low-lead construction: no more than 0.25% weighted average lead content on wetted surfaces
• Rated 125 WSP and 200 WOG for reliable pressure service
• Manufactured to Alloy No. C84400 per ASTM B584
• Meets ANSI/ASME B16.15 and ANSI B1.20.1 threaded fitting standards
• Complies with California AB 1953 and Vermont SB 152 low-lead laws
• Meets WW-P-460 Federal Specifications

Compatibility

Designed as an OEM-style replacement and standard-fit threaded pipe cap for 3/8 inch NPT threaded pipe ends in residential and commercial plumbing and mechanical systems.

Installation Notes

Installation is performed by a licensed plumber or pipefitter following applicable IPC and local plumbing code requirements. Shut off and depressurize the line before installing or removing any threaded fitting. Apply an appropriate thread sealant or PTFE tape to the male threads before threading the cap on by hand, then tighten with a pipe wrench to achieve a leak-free seal. Do not overtighten, as this can crack brass fittings or damage threads.