Anderson Metals 736112-06 Brass Pipe Nipple 1 in Npt

Product Description

The ANDERSON METALS 736112-06 is a close-pattern brass pipe nipple threaded on both ends, designed for use in low-pressure plumbing, gas distribution, and fluid-handling applications. Manufactured from red brass, this nipple measures 1 inch overall length with a 3/8-inch outside diameter and NPT threading on both ends. It meets lead-free requirements, making it suitable for potable water systems where lead-free compliance is mandated. Licensed plumbers and pipefitters use this type of fitting to extend or connect threaded pipe runs in tight spaces where a full-length nipple is not practical.

This nipple is commonly installed in residential and light commercial plumbing systems, hydronic heating lines, compressed air supply lines, and gas piping where 3/8-inch NPT connections are required. Its compact 1-inch OAL makes it well suited for close-coupled connections between valves, fittings, and equipment. The red brass construction resists dezincification and corrosion, making it a reliable choice in both wet and dry service environments.

Key Features

• Lead-free red brass construction meets potable water compliance requirements
• NPT threading on both ends for standard tapered thread engagement
• 1-inch overall length for close-coupled fitting connections
• 3/8-inch outside diameter for compatibility with standard 3/8-inch NPT fittings
• Corrosion-resistant material suitable for water, gas, and air service

Compatibility

Designed as a standard 3/8-inch NPT threaded pipe nipple for use with any fitting, valve, or equipment port accepting 3/8-inch NPT male connections in plumbing, HVAC, or gas piping systems.

Installation Notes

Installation should be performed by a licensed plumber or qualified pipefitter in accordance with applicable local plumbing codes and IFGC requirements for gas applications. Shut off and depressurize the line before removing or installing any threaded fitting. Apply an approved thread sealant or PTFE tape to the NPT threads before assembly, and tighten to a snug fit using a pipe wrench — avoid overtightening, which can crack fittings or strip threads. Verify system pressure rating does not exceed the fitting specification before returning to service.