Amprobe ACDC-3400 Ind Clamp Meter 1000V Cat Iii Cat Iv

Product Description

The AMPROBE ACDC-3400 IND is a professional-grade clamp meter designed for measuring AC and DC electrical parameters in commercial and industrial environments. It handles up to 750 volts AC and 1,000 volts DC, and measures current up to 1,000 amps DC using its 2.2441-inch clamp-on jaw. The meter delivers True RMS AC waveform measurement and a 6,600-count digital display, giving technicians accurate readings on non-sinusoidal loads. In addition to voltage and current, it measures capacitance, resistance up to 66 megohms, and frequency, making it a versatile single-instrument solution for electrical diagnostics.

This clamp meter is suited for licensed electricians, HVAC technicians, and industrial maintenance professionals working on commercial power distribution, motor circuits, HVAC control panels, and similar electrical systems. Its CAT III and CAT IV safety ratings make it appropriate for use on building services equipment, distribution boards, and outdoor supply conductors. The included case, manual, and test leads allow for immediate deployment on the job site without additional accessories.

Key Features

• True RMS AC measurement for accurate readings on variable-frequency and non-linear loads
• 1,000 volt DC and 750 volt AC maximum voltage ratings
• 1,000 amp DC maximum current capacity via clamp-on jaw
• 2.2441-inch jaw opening accommodates larger conductors and conduit runs
• 6,600-count digital display for high-resolution readings
• Measures capacitance, resistance (up to 66 megohms), frequency, current, and voltage in one tool
• Rated to IEC 61010 and IEC 61326 safety and EMC standards

Compatibility

Designed as a general-purpose clamp meter for use on AC and DC electrical systems rated within CAT III and CAT IV overvoltage categories, including commercial distribution panels, industrial motor circuits, and building service entry points.

Installation Notes

Installation and testing with this meter should be performed by a qualified electrician or licensed trade professional familiar with NFPA 70 (NEC) requirements and appropriate PPE for the voltage category being measured. Always verify the circuit voltage category does not exceed the meter's CAT rating before clamping onto a conductor. Do not exceed the rated voltage or current maximums listed on the meter. Ensure test leads are in good condition and fully rated for the measurements being taken.