Amerimax Home Products 66014 Aluminum Versa Flashing 14x50

Product Description

The AMERIMAX HOME PRODUCTS 66014 is a mill-finish aluminum versa flashing roll used to seal and weatherproof transitions, penetrations, and joints in roofing, siding, and related building envelope assemblies. At 14 inches wide and 50 feet long, this roll provides substantial coverage for larger flashing runs without mid-job splicing. The aluminum substrate is 0.0078 inches thick, balancing formability with durability in exterior applications. Roofers, siding contractors, and general construction trades install this product as part of moisture management systems on residential and light commercial structures.

This flashing roll is suited for step flashing, counter flashing, through-wall applications, and custom pan or valley flashing fabrication. The mill finish aluminum accepts paint and coatings and resists corrosion in typical exterior environments. The 14-inch width accommodates wider coverage zones that narrower rolls cannot handle in a single pass, reducing overlap seams and installation time on large or complex assemblies.

Key Features

• Mill finish aluminum surface accepts field-applied coatings and paint
• 0.0078-inch material thickness provides workable flexibility for bending and forming on site
• 14-inch width reduces the number of seams required on wide flashing zones
• 50-foot roll length minimizes mid-run splices on longer flashing applications
• Aluminum construction resists corrosion in standard exterior exposure conditions

Compatibility

Designed as a general-purpose aluminum flashing roll for use in residential and light commercial roofing, siding, and building envelope moisture control assemblies where a 14-inch-wide aluminum flashing material is specified.

Installation Notes

Installation is typically performed by licensed roofing or siding contractors following local building code requirements and manufacturer flashing guidelines. Cut aluminum flashing with sheet metal snips or a utility knife and straightedge; wear gloves as cut edges are sharp. All fasteners and adjacent metals should be compatible with aluminum to prevent galvanic corrosion. Follow applicable building codes for overlap dimensions, sealant use, and fastener spacing at all flashing terminations.