American Saw Mfg Co 2060577 Bi-metal Hole Saw 3/4 Inch

Product Description

The AMERICAN SAW MFG CO 2060577 is a 3/4 inch (19mm) bi-metal hole saw designed for cutting through both wood and metal. It features a Vari Tooth design with positive rake teeth that deliver deep, aggressive cutting action while resisting shock and tooth breakout during demanding applications. The Speed Slot design built into the body speeds up plug removal after each cut, reducing downtime on the job. This hole saw is suited for electricians, plumbers, HVAC technicians, and general contractors who need a reliable, fast-cutting hole saw for daily trade work.

This hole saw is used in residential and light commercial applications where clean, accurate holes are needed in wood framing, sheet metal, conduit plates, or similar materials. The 3/4 inch diameter makes it well suited for smaller penetrations such as low-voltage wiring runs, conduit knock-outs, and pipe access holes. It is compatible with standard 1L, 4L, and 5L arbors as well as the 5L Snap Back arbor, giving technicians flexibility with existing tooling already on the truck or in the shop.

Key Features

• 3/4 inch (19mm) cutting diameter for precise, smaller-diameter penetrations
• Bi-metal construction provides durability across wood and metal substrates
• Vari Tooth design with positive rake angle for deep, aggressive cutting action
• Shock resistant teeth reduce breakage during interrupted cuts in mixed materials
• Speed Slot design accelerates plug removal after each cut
• Compatible with 1L, 4L, 5L standard arbors and 5L Snap Back arbor

Compatibility

Designed for use with 1L, 4L, and 5L standard arbors or the 5L Snap Back arbor. Suitable for cutting wood and metal in typical trade installation scenarios.

Installation Notes

This hole saw is installed by electricians, plumbers, and HVAC technicians as part of standard rough-in and service work. Ensure the arbor is securely seated and the pilot bit is sharp before beginning a cut. Use appropriate speed settings on the drill for the material being cut — slower speeds are generally recommended for metal. Always wear eye protection and secure the workpiece before drilling.