Adams Rite 7140-310-626-00 Electric Strike 12V Dc

Product Description

The ADAMS RITE 7140-310-626-00 is an electric strike designed for access control applications in commercial and institutional door hardware installations. Operating on 12 volts DC, this strike replaces the fixed strike plate in a door frame and allows the latch bolt to retract electrically upon receiving an access signal, enabling entry without direct mechanical actuation of the handle from the outside. The satin chrome finish provides a clean, professional appearance suited to aluminum storefront and hollow metal frame door systems. Locksmiths, door hardware installers, and access control technicians are the primary trades who specify and install this unit.

Electric strikes of this type are commonly installed in commercial storefronts, office entryways, multifamily building vestibules, and institutional facilities where controlled access is required at a single door or as part of a broader access control system. The 12V DC operating voltage makes it compatible with standard low-voltage access control panels, card readers, keypads, and intercom-integrated power supplies commonly found in these environments. The satin chrome finish matches widely used aluminum door hardware in commercial applications.

Key Features

• 12V DC operating voltage compatible with standard low-voltage access control power supplies
• Electric strike configuration allows remote release of latch without mechanical handle operation from exterior
• Satin chrome finish for use with aluminum storefront and commercial hollow metal frame doors
• Sold individually as a single unit replacement or new installation component
• Part of the ADAMS RITE 7140 series electric strike product line

Compatibility

Designed as an OEM-style replacement or new installation electric strike for commercial door frames requiring a 12V DC low-voltage electric strike in satin chrome finish.

Installation Notes

Electric strikes are installed by licensed locksmiths or access control technicians and must be wired in compliance with applicable local electrical codes and the NEC for low-voltage systems. Disconnect and de-energize the access control power supply before beginning installation or service work. Verify that the frame prep, latch bolt geometry, and strike cavity dimensions are compatible before mounting. Do not apply line voltage to this device as it is rated for low-voltage DC operation only.