Accupro 71176762 Diamond Pattern Router Bit 0.25in Dia

Product Description

The ACCUPRO 71176762 is a solid carbide diamond pattern router bit designed for cutting and trimming fiberglass composite materials. With a 0.25 inch cutter diameter and a 1 inch length of cut, this bit delivers clean, controlled material removal in routing applications where fiber pullout and delamination are common failure points with lower-quality tooling. The drill point end type allows plunge entry without a pre-drilled pilot hole. The bright uncoated finish is standard for solid carbide tooling used in abrasive non-metallic materials. This bit is used by skilled tradespeople, fabricators, and shop technicians working with fiberglass panels, ducting, and composite assemblies.

This router bit is suited for fiberglass routing applications in HVAC fabrication, marine composite work, and industrial panel trimming. The right-hand cutting direction is compatible with standard CNC routers and handheld routing equipment that uses a 0.25 inch shank collet. The 3 inch overall length provides adequate clearance for typical panel thickness and fixture setups. It is sold individually and is intended for professional use where consistent edge quality in fiberglass is required.

Key Features

• Diamond pattern flute geometry reduces fiber pullout in fiberglass cutting
• Solid carbide construction provides hardness and wear resistance in abrasive composite materials
• Drill point end allows direct plunge entry without a pilot hole
• Bright uncoated finish standard for solid carbide fiberglass tooling
• Right-hand cutting direction compatible with standard routing equipment
• 0.25 inch shank fits common 1/4 inch collet routers and CNC spindles

Compatibility

Designed for use in standard 0.25 inch collet routers and CNC routing spindles. Material application is fiberglass as specified by the manufacturer.

Installation Notes

Installation and use of this router bit should be performed by qualified machinists or fabricators familiar with CNC or handheld routing equipment. Ensure the router is fully powered down and the collet is released before changing bits. Verify collet size matches the 0.25 inch shank before tightening. Always use appropriate eye protection and dust control when routing fiberglass, as airborne glass fiber particles are a respiratory and skin hazard.