3M 7010328707 Silicon Carbide Deburring Wheel 4 Inch

Product Description

The 3M 7010328707 is a unitized silicon carbide deburring wheel designed for edge finishing, light deburring, and surface blending on metal workpieces. Built with a Density 7 hard-grade construction, this wheel delivers consistent cut and finish performance across the contact face. At 4 inches in diameter and 0.25 inches wide, it mounts on a 0.25-inch center arbor and runs at a maximum rated speed of 12,100 RPM. The unitized construction bonds abrasive fibers throughout the wheel body, so performance stays consistent as the wheel wears down over time.

This deburring wheel is suited for use in fabrication shops, job sites, and maintenance environments where controlled material removal is required on metal parts. It is compatible with centerless grinders, die grinders, inline sanders, manual backstands, and pressure assist backstands. The silicon carbide abrasive makes it a practical choice for finishing harder, more brittle materials where a sharper cutting action is needed. Sold individually.

Key Features

• Silicon carbide abrasive for sharp, consistent cutting action on hard materials
• Density 7 hard-grade unitized construction maintains performance as wheel wears
• 4-inch diameter with 0.25-inch face width for precise edge and surface work
• 0.25-inch center hole fits standard arbors on die grinders and inline sanders
• Rated to 12,100 RPM maximum for use with high-speed rotary tools
• Compatible with centerless grinders, die grinders, inline sanders, and backstands

Compatibility

Compatible with centerless grinders, die grinders, inline sanders, manual backstands, and pressure assist backstands that accept a 0.25-inch arbor and operate within the 12,100 RPM maximum speed rating.

Installation Notes

Install on a grinder or inline sander with the tool powered off and the air or electrical supply disconnected before mounting. Verify the tool spindle speed does not exceed the 12,100 RPM maximum rating stamped on the wheel. Inspect the wheel for cracks or damage before each use and do not use a damaged wheel. Follow ANSI B7.1 safety standards and wear appropriate PPE including eye and face protection during operation.