3M 7000149317 Heat Shrink Cable Sleeve 1kv 6in Itcsn

Product Description

The 3M 7000149317 is a heavy-wall heat shrink cable sleeve in the ITCSN-1100 series, designed for electrical splices, connections, and terminations up to 1 kV. Constructed from cross-linked polyolefin with a factory-applied internal adhesive and sealant, it delivers mechanical and environmental protection once shrunk in place. The sleeve accepts wire sizes from 2 AWG through 4/0 AWG, with a supplied inner diameter of 1.10 inches recovering to 0.37 inches. The 6-inch cut-to-length design is split resistant and fast shrinking, reducing installation time on the job. Licensed electricians and utility splice technicians are the primary installers of this product.

This sleeve is suited for residential, commercial, and light industrial electrical applications where a reliable, moisture-resistant splice or termination is required. It is used on power cables, feeder runs, and service entrance conductors within the 2 AWG to 4/0 AWG range. The adhesive liner creates a waterproof seal when the sleeve is fully recovered, making it appropriate for both indoor and direct-exposure outdoor installations. Each sleeve is sold individually as a single 6-inch piece.

Key Features

• Cross-linked polyolefin construction — highly split resistant and dimensionally stable after recovery
• Factory-applied internal adhesive and sealant provides a watertight environmental seal
• Fast shrink rate for rapid installation, reducing time on splice and termination work
• Rated to 1 kV; UL Listed 486D for 600V (File Number E102356); CSA rated
• Supplied inner diameter of 1.10 inches recovering to 0.37 inches — fits 2 AWG through 4/0 AWG conductors
• 6-inch length suitable for standard splice and termination coverage

Compatibility

Designed for use with 2 AWG through 4/0 AWG copper or aluminum conductors in splicing, connection, and termination applications rated up to 1 kV.

Installation Notes

Installation should be performed by a qualified electrician following applicable NEC requirements. De-energize and lock out the circuit before beginning any splice or termination work. Apply heat evenly along the sleeve using an appropriate heat gun, working from the center outward to avoid trapping air under the adhesive liner. Do not use an open flame, as uneven heat can cause incomplete recovery or damage to the sleeve material.

Technical Specifications

• Voltage Rating: 1 kV (UL Listed 486D at 600V)
• Wire Range: 2 AWG to 4/0 AWG
• Supplied Inner Diameter: 1.10 inches
• Recovered Inner Diameter: 0.37 inches
• Length: 6 inches
• Material: Cross-linked polyolefin
• Adhesive Liner: Factory-applied adhesive and sealant
• UL Listing: 486D, File Number E102356
• CSA Rating: Yes
• Weight: 0.08 pounds
• UOM: Each
• Minimum Order Quantity: 25

Standard Information

• Brand: 3M
• Manufacturer Part Number: 7000149317