3M 7000055558 Photoluminescent Film 6900 48in X 50yd

Product Description

The 3M 7000055558 is a high-performance photoluminescent film engineered for safety markings, emergency exit signage, and egress path identification. The film absorbs ambient light and re-emits it as a visible glow-in-the-dark output, eliminating the need for electrical power during low-light or power-failure conditions. It ships as a single 48-inch-wide by 50-yard roll, weighing 55 pounds. The glossy, light yellow-green surface carries a permanent pressure-sensitive adhesive backing, allowing direct application to flat or low-contour surfaces. Facility managers, safety contractors, and commercial sign fabricators are the primary installers.

This film is suited for commercial, industrial, and institutional environments where code-compliant emergency egress marking is required. Typical applications include stairwell egress paths, exit door frames, floor proximity markings, and safety sign face stock. The large-format roll supports production-scale sign fabrication or long continuous runs of floor and wall striping. Interior use on clean, dry surfaces is the standard installation scenario.

Key Features

• Photoluminescent glow-in-the-dark performance — recharges under ambient or UV light, no power source required
• Permanent pressure-sensitive adhesive backing for direct surface application
• Glossy finish with light yellow-green color suited for high-visibility safety markings
• Large-format roll: 48 inches wide by 50 yards — supports continuous runs and production sign cutting
• Designed for emergency exit and egress signage applications in commercial and institutional settings

Compatibility

Designed as a large-format photoluminescent film roll for use in fabricating safety signs, egress markers, and emergency exit graphics on clean, smooth interior surfaces.

Installation Notes

Surface preparation is critical — clean the substrate thoroughly and allow it to dry completely before applying the pressure-sensitive adhesive. Application should be performed by a qualified safety contractor or sign fabricator familiar with local building and fire codes, including IFC and NFPA 101 egress marking requirements. Avoid trapping air bubbles by using a firm squeegee during application. Do not apply to textured, porous, or damp surfaces, as adhesion will be compromised.